Fiat 500 / Ford Ka(?) Shift Cable Bushing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement rubber insert for the shift bushings of Fiat 500 5 speed manual transmissions and maybe the Ford Ka
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 13
- Makes
- 0
- Views
- 97
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
Unwilling to spend $400 on a set of shift cables to replace the bushings that unscrew and are not even permanently attached, and could be sold separately if Stellantis wasn't run by the antichrist?
Willing to put a 3d printed part 6 inches from the engine?
This is the model for you!
INSTRUCTIONS
Remove shifter cable bushing with 2 10mm wrenches
Fully separate inner mount (to transmission) from outer mount (to cable)
Use sanding wheel on dremel and degreaser to remove all of the old rubber and prepare the surface for gluing
Print the model SOLID out of a TPU material. I used Polymaker TPU95-HF to great success
Superglue the inner into the middle of the bushing and the bushing into the middle of the outer
Wait 5 minutes before fitting onto vehicle
DISCLAIMER / WARNING
I have been driving my Fiat like this for a while now and so far everything is just fine. Don't use anything that melts at a lower temperature than Polymaker TPU95-HF. Don't use a hard plastic. Make sure the surfaces are totally clean before gluing.