Toyota MR2 SW20 & AW11 [1984-1999] shifter drop plate and shifter cup shim
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lower the OEM shifter by 3-9.5mm
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 11
- Makes
- 1
- Views
- 106
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
About the design
This drop plate combines aspects of the B&M plate (circular opening) and various generic drop plates (rectangular opening) resulting in an oblong opening. This approach minimizes the risk of interference when used with different shifters, transmissions, and shift-cable lengths. The OEM shifter base plate can be modified with a Dremel tool to match. There are two variations of the drop plate:
standard model requires full disassembly of the shifter to install
slip-through model has a gap to pass the shifter-shaft through (no need to remove knob or cables)
The drop plate .stl is 6mm thick which is similar to the 1/4" (6.35mm) generic plates available on eBay. Up to 9.5mm will work but a layer of sound deadening material may need to be removed on some cars. Longer fasteners are required as follows:
For ~9.5mm, four M8 x 25mm (1mm fine thread) bolts/washers are required
For ~6mm, two M8 x 25mm bolts/washers are required (two OEM bolts can be re-used)
Optional parts
Shifter cup shim - SW20 Gen2 and later (1993+) OEM shifters include a shim (Toyota part 90564-37019) which rests above the shifter cup retention spring. You can print my replica of this part to include on older shifters to prevent the spring from rattling or falling out during re-assembly.
Install tips
Superklasse Shifter parts install guide (https://archive.is/KM1EA)
How to re-condition your gear selector (https://archive.is/vAjma)
Printing tips
In general, parts like these should be manufactured with CNC Aluminum, Delrin, or HDPE using the .dxf files. For FDM 3D-printing, .stl files are included and the following settings will work OK:
PETG, ABS, or ASA OK (PA11/Nylon, PC-blend, PP-CF, PETG-CF preferred)
0.2mm layer height
6+ perimeters (0.4mm nozzle) or 4+ perimeters (0.6mm nozzle)
5+ top/bottom layers
50% gyroid infill (100% rectilinear/monotonic infill OK but won't improve strength)