1 1/4 inch PVC Fittings
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I used the original design by mikeeg and am adapting them for 1 1/4 inch PVC.
- Rating
- 0 / 5
- Likes
- 25
- Downloads
- 212
- Makes
- 0
- Views
- 1,310
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
Edit: May 04, 2022 I ended up printing this at 100.5% which seemed to be the best fit. 100% was a bit too tight and 101% was too loose. Split the difference to get a nice snug, but workable fit!
I remixed this because I have a lot of 1 ¼ inch PVC that I use for network cable conduit between rooms and attic. I found that the typcial 90 degree bend was way too tight to efficiently pull cable through, so I adapted this to fit the 1 ¼ inch pipe. The inner diameter of the bend is the same allowing for a better pull radius!
I printed on its side with tree supports only to support the bottom part. It fits really tight on the pipe so 101% scale might be recommended.
I printed with 5% fill, 3 walls, and raft, given the little surface area the print has to the bed.
I will upload the others as I finish them!