Sonoff SNZB-03 AA Battery Enclosure (Mod for Extreme Battery Life)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case to convert your Sonoff SNZB-03 to 2x AA batteries.
- Rating
- 5 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 1
- Views
- 49
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Annoyed by constant battery changes on your Sonoff SNZB-03 motion sensor? The standard coin cells drain way too fast. This 3D-printed replacement housing solves the problem once and for all!
With this mod, you can convert the motion sensor to run on two standard AA batteries. The result is a massively extended battery life (often lasting several years) and less e-waste from expensive coin cell batteries.
🌟 Features
Extreme battery life: Forget about constantly swapping out CR2450 coin cells.
Cost-effective operation: Uses cheap, standard AA batteries or rechargeables.
Perfect fit: Specifically designed to house the original Sonoff SNZB-03
🛠 Bill of Materials (BOM)
In addition to the 3D-printed parts, you will need a few standard components:
1x The Sonoff SNZB-03 motion sensor
2x AA batteries
4x AA battery contacts/terminals (2x with a spring for the negative pole, 2x flat for the positive pole)
A short piece of wire (2 cores, e.g., red and black)
Basic tools: Soldering iron, solder, and super glue (optional, to secure the contacts if needed)
⚠ Disclaimer: This modification is done at your own risk. Soldering onto the PCB will void the manufacturer's warranty of your Sonoff sensor.
The lid is not perfectly made tbh. u can see that on the pictures, i will adjust it somewhen, but it does its job.
I also cut the edges of the sonoff case a bit, since they have some kind of a little bumps there.
Used AI to write the desciption :)