Electronics Storage Tubes optimised for Vase Mode (Gridfinity)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Gridfinity tray (12U) with 16 vase mode optimized electronics storage tubes for various through-hole components.
- Rating
- 0 / 5
- Likes
- 17
- Downloads
- 53
- Makes
- 0
- Views
- 236
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
As some others I spent a long time trying to find a good way for stroring resistors and found the aproach from @JohnOldman.
With additional inpiration from @KWECustoms_2741705 for lager tubes fitting nicely into gridfinity units.
My design variation uses the 4-to-3 gridfinity adaption and tubes with a footprint of 24mm but with a height so that the tubes with lids and gridfinity bin together have a heigt of 12U gridfinity.
Design goal was to use vase mode for the tube an lids so I changed the holes for the snap in favor for notches.
Printing Instructions
For the tubes and lids, it is crucial to print them with a line width of 0.8mm (0.6mm may also work). This usually works very well with 0.4 mm nozzles in vase mode.
I also attach 3MF files with sequential printing 16 tubes in vase mode on a CoreOne+ and 12 lids on a Mini+ for reference (but slice it your self with your dialed in settings).
For some speed optimization I seeked the filament cooling limit because theses parts are so small speed depends sole on cooling. In my case I got down to 5 sec on the Mini+ (55min printing 12 lids on full mini+ bed) and down to 2 sec on the CoreOne+ (3h 51min 16 tubes on full CoreOne+ bed) for the tubes.