Intel CPU Fan Mount for Reuse - 80mm to 92mm - High-speed Cooler Mounting System
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
If you need a high speed fan, don't throw away that old computer just yet. Grab the fan and print a mount.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 10
- Makes
- 0
- Views
- 119
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
The Intel CPU fans designated as 80mm (due to fan diameter) are awkward and bulky, so I made this enclosure with mounting holes on both sides with an 82.5 mm offset to match the 92mm computer fan standard.
You can use any standard 92mm fan accessories such as filters or grills (factory-made or 3D printed) with this.
Use M3 screws if you have heat-set inserts. Otherwise you could try using the large tap screws that come with computer fan accessories.
Assembly:
After printing, cut the sacrificial wall: from the ~84mm hole all the way to the DC jack mounting hole to allow putting the wire in from the side (See photos).
(Optional) Add a DC jack: Unscrew the nut from the jack, put the wires through the nut, then solder a DC jack to the yellow (+) and black (-) wires.
Clip the fan onto the outlet (small part).
Run the wire through the inlet (large part).
Keep pulling the wire tight as you press the two parts together, to keep the wire from being crushed (See photo with wire not fully installed).
Slide the wire through the slot and into the triangular chamber (loosely for now).
Slide the yellow and black wire back out of the round hole.
Press the DC jack into the hole.
Tighten the wire and use a zip-tie to mount the wires tightly to the zip-tie mount (but still loose on the triangular chamber side).
Press the remaining slack from the wires into the triangular chamber until flat (See photo showing the fully-assembled enclosure next to the optional stand).
These are the bare essentials to make these fans mountable in a standard way. I use this for spills (such as on parts and tight spaces) since it is a high-speed fan. With plain DC and no PWM control, it is always at max speed. To use it that way you can use the "stand," but to mount the intake side to chassis or other 92mm fan accessories, instead use the "intake adapter" to convert from the 3+1 screw arrangement (avoiding wiring compartment) to a standard 4-screw (symmetrical) arrangement.
Print with brim (full is fine but "Mouse Ears" worked for me and are easy to remove) on the intake cover.
If you make new accessories and mounts please post them under "Remix." I might use them or make more!