1 / 3
Flower pot anchor V2 / Blumentopfsicherung V2 — image 1
1 / 3

Flower pot anchor V2 / Blumentopfsicherung V2

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Clamp for securing flower pots during storms; designed to be attached to beams w. edge length of approximately 95–100mm

Rating
0 / 5
Likes
0
Downloads
2
Makes
0
Views
6
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

EN:

I have a flower pot with a small tree on either side of the entrance. However, whenever the wind picked up, one or both of them would keep falling over. So I designed a simple clamp that will hopefully solve the problem. It’s certainly a very specific design that will rarely fit anywhere, but it can be adjusted to a limited extent in the slicer by scaling it up or down. Since my wife wanted a different arrangement of the pots > Version 2. Only one file is needed for this version, as they are bilaterally symmetrical.

Version 1 see https://www.printables.com/model/1671141-flower-pot-anchor-blumentopfsicherung/files

Material: PLA

Layer height: 0.3 mm

Supports: none

Perimeter: 5

Infill: 80%

FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF

DE:

Haben links und rechts des Eingangs je einen Blumentopf mit kleinem Bäumchen stehen. Bei stärkerem Wind fiel jedoch immer wieder einer oder beide um. Habe daher eine einfache Klammer konstruiert, die das Problem hoffentlich beseitigt. Ist sicherlich eine sehr spezielle Konstruktion, die nur selten wo passen wird, kann aber im Slicer durch Vergrößern oder Verkleinern in begrentztem Umfang angepasst werden. Da meine Frau eine andere Anordnung der Töpfe wollte > Version 2. Von dieser wird nur eine Datei benötigt, da sie seitensymmetrisch sind.

Version 1 siehe https://www.printables.com/model/1671141-flower-pot-anchor-blumentopfsicherung/files

Material: PLA

Schichten: 0.3mm

Stützen: keine

Perimeter: 5

Infill: 80%

Tags