Traxxas Rustler 4WD VXL GoPro Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a Go Pro mount for the roof of the Rustler 4WD VXL
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 127
- Makes
- 0
- Views
- 905
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
This is a GoPro mount for the Rustler 4WD VXL - it might fit others but I've none to test with.
It is intended to replace the roof bars, which are held on by four screws from inside the body. I experimented with a few designs, but settled on this two part one in the end. The curve of the roof was too much for my printer to print without supports and the amount of supports needed meant removal was a complete pain.
Print the roof panel upside down and the mount sitting upright and it should be good. You'll need a couple of M3x8mm counter sunk screws (or perhaps some superglue) to mount the two bits together.
Its symmetrical, so simply put it on backwards if you want the camera to record facing that way.
The mount is intentionally off centre by 15mm to try and get the lens of the camera lined up with the centre line of the body.