Replacement retaining nut for GF Garden GF80005073 double outlet tap connector
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement retaining collar for the upper connector of a GF Garden double outlet tap connector.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 2
- Makes
- 0
- Views
- 34
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Replacement retaining collar / nut for the upper connector of the GF Garden double outlet tap connector.
This is not an official GF Garden part. It was recreated parametrically from measurements and photos after the original white retaining ring cracked. The printed version was tested successfully.
Known compatibility:
- GF Garden GF80005073
- Probably GF80043073, based on the official product page, but not physically tested by me.
Official product page:
https://gfgarden.it/fr/products/presa-rubinetti-doppia-uscita-1
Technical dimensions:
- Height: 19 mm
- Outer diameter: 50 mm bottom, 47 mm top
- Top retaining opening: 35.2 mm
- Internal rounded thread pitch: 1.833333 mm
- Internal thread root diameter: 43.25 mm
- Internal thread crest diameter: 40.60 mm
- Thread direction in generator: THREAD_DIRECTION = -1.0
Tested print settings:
- Material: SUNLU PLA+
- Nozzle: 0.4 mm
- Layer height: 0.16 mm
- Walls: 6
- Infill: 40% gyroid
- Brim: 7 mm
- Supports: no
PETG or ASA is likely a better choice than PLA+ for long-term outdoor/water use. Watertightness depends mainly on the seal and tightening, not on the printed plastic alone.