Dell OptiPlex 3010 7010 9010 SFF PSU to ATX Adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows you to install the funnily shaped PSU from an old Dell OptiPlex computer where you'd install a standard ATX one.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 21
- Makes
- 0
- Views
- 249
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I was tasked with scrapping 2 old Dell OptiPlexes. Instead of binning all the parts, I set about reusing as many of them as possible. This model allows you to re-use the PSU in a standard computer case. Be aware that it may collide with the DVD drive.
You will almost certainly need a 24 pin extension cable. It's surely better to buy a cheap cable than a whole PSU. Plus, it's a huge amount of waste prevented.
Due to its length and weight, the PSU may sag. I solved that problem with a Fujitsu E400 PSU by supporting it with a screw in the 5.25" front panel bay. Be creative! Or just leave it as it is. It'll probably be fine :)
- PLA, PETG or ABS
- 0.2mm layer height
- 20% infill
- 7x #6-32 UNC screws - 3 to mount the PSU, 4 to mount the bracket to the case
If this model is useful to you, consider checking out my YouTube channel (https://www.youtube.com/@RepairWins) I cover electronics repair, electronics modding, the odd DIY project, woodworking (if you stand a mile away and squint) and much more.