Dell OptiPlex 3010 7010 9010 SFF PSU to ATX Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows you to install the funnily shaped PSU from an old Dell OptiPlex computer where you'd install a standard ATX one.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 243
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was tasked with scrapping 2 old Dell OptiPlexes. Instead of binning all the parts, I set about reusing as many of them as possible. This model allows you to re-use the PSU in a standard computer case. Be aware that it may collide with the DVD drive.
You will almost certainly need a 24 pin extension cable. It's surely better to buy a cheap cable than a whole PSU. Plus, it's a huge amount of waste prevented.
Due to its length and weight, the PSU may sag. I solved that problem with a Fujitsu E400 PSU by supporting it with a screw in the 5.25" front panel bay. Be creative! Or just leave it as it is. It'll probably be fine :)
- PLA, PETG or ABS
- 0.2mm layer height
- 20% infill
- 7x #6-32 UNC screws - 3 to mount the PSU, 4 to mount the bracket to the case
If this model is useful to you, consider checking out my YouTube channel (https://www.youtube.com/@RepairWins) I cover electronics repair, electronics modding, the odd DIY project, woodworking (if you stand a mile away and squint) and much more.