BMW 1 Series (F70) Qi wireless Charging Pad
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Upgrade your BMW 1 Series (F70) with a sleek, custom-fitted wireless charging pad. This 3D-printed insert fits perfectly
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 90
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Upgrade your BMW 1 Series F70 (2024-...) with a sleek, custom-fitted wireless charging pad. This 3D-printed insert fits perfectly into the center console storage area, providing a clean, factory-like look while keeping your phone juiced up on the go.
Required Hardware & Bill of Materials
To complete this build, you will need the 3D-printed part plus the following components:
Wireless Charger (Teardown Required): * INIU 15W Wireless Charging Pad (Amazon FR)
Note: You will need to carefully disassemble/tear down this charger to extract the bare Qi PCB and charging coil.
Shortened USB-C Cable: * Right-Angle Short USB-C Cable (Amazon FR)
Note: To keep the installation ultra-clean and compact inside the console, you will need to desolder the original cable on the Qi pad and solder this shorter one directly to the PCB.
Assembly Instructions
Disassemble the Charger: Carefully pry open the wireless charger casing to remove the main PCB circuit board and the attached copper induction coil & magnets.
Solder the Short Cable: Desolder the stock long cable from the PCB. Solder the short, USB-C cable in its place, paying close attention to the correct wiring.
Mount to the Print: Fit the bare induction coil and PCB into the designated slots/recesses on the underside of your 3D-printed pad. Secure them using a bit of hot glue.
Install in Car: Drop the completed pad into your BMW F70 console and plug the short USB-C cable directly into the car's adjacent USB port.