1 / 1
Low(ish)-Profile Airflow Concentrator for 120mm Fans (Desk Fan Nozzle) — image 1

Low(ish)-Profile Airflow Concentrator for 120mm Fans (Desk Fan Nozzle)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A compact, quiet 120mm fan shroud that focuses airflow into a coherent stream - with integrated de-swirl vanes.

Rating
0 / 5
Likes
3
Downloads
10
Makes
0
Views
75
Reviews
0

Updated at source:

Model information

License
Creative Commons — Public Domain

At least with my fan it works substantially better than the NV-AA1-12 Airflow Amplifier by Noctua, and it is a lot smaller and lighter.

A 3D-printable nozzle that turns a standard 120mm PC fan into a focused personal desk fan. It bolts to the fan's exhaust side and concentrates the output into a defined, aimable stream instead of the broad, swirling spread a bare fan produces.

Unlike a simple cone, this isn't just a converging duct — the focusing comes as much from cleaning up the flow as from the taper:

  • De-swirl vanes — 7 straight radial vanes straighten the fan's rotational swirl so the stream stays coherent and holds together at arm's length. The count is chosen coprime to common 9-blade fans to avoid a reinforced tone.

  • Hub fairing — a smooth semi-ellipsoid nose fills the dead-air wake behind the motor hub, so you get a filled column instead of a donut with a dead center.

  • Cosine (S-curve) contraction — the wall eases in and out with no sharp corners, and the flow leaves axially for a clean parallel jet.

  • Tone-free finger guard — concentric rings (not radial spokes) keep fingers out of the blades without the whistle a normal guard adds, since axisymmetric rings create no blade-pass tone.

It's low-profile (~30mm deep), light (~42g in PLA), and prints as a single piece flange-down — no supports needed except optionally inside the hollow fairing.

Fit: designed around a standard 120mm frame with the 105mm bolt pattern (M4). The center fairing is sized for a ~35mm motor hub; if yours differs, adjust in the source. Tested on an ARCTIC F12 PWM PST.

Design aid: I got claude to help me with the OpenSCAD code and suggest features and parameters.

Parametric: the included OpenSCAD file exposes every dimension — outlet size (focus vs airflow), duct length, vane count/height, ring spacing (finger gap), fairing length, and wall thicknesses — so you can retune it for a different fan, focus level, or profile without CAD work. STL is provided ready to print.

Print notes: no supports needed

Tags