Low(ish)-Profile Airflow Concentrator for 120mm Fans (Desk Fan Nozzle)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A compact, quiet 120mm fan shroud that focuses airflow into a coherent stream - with integrated de-swirl vanes.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Public Domain
At least with my fan it works substantially better than the NV-AA1-12 Airflow Amplifier by Noctua, and it is a lot smaller and lighter.
A 3D-printable nozzle that turns a standard 120mm PC fan into a focused personal desk fan. It bolts to the fan's exhaust side and concentrates the output into a defined, aimable stream instead of the broad, swirling spread a bare fan produces.
Unlike a simple cone, this isn't just a converging duct — the focusing comes as much from cleaning up the flow as from the taper:
De-swirl vanes — 7 straight radial vanes straighten the fan's rotational swirl so the stream stays coherent and holds together at arm's length. The count is chosen coprime to common 9-blade fans to avoid a reinforced tone.
Hub fairing — a smooth semi-ellipsoid nose fills the dead-air wake behind the motor hub, so you get a filled column instead of a donut with a dead center.
Cosine (S-curve) contraction — the wall eases in and out with no sharp corners, and the flow leaves axially for a clean parallel jet.
Tone-free finger guard — concentric rings (not radial spokes) keep fingers out of the blades without the whistle a normal guard adds, since axisymmetric rings create no blade-pass tone.
It's low-profile (~30mm deep), light (~42g in PLA), and prints as a single piece flange-down — no supports needed except optionally inside the hollow fairing.
Fit: designed around a standard 120mm frame with the 105mm bolt pattern (M4). The center fairing is sized for a ~35mm motor hub; if yours differs, adjust in the source. Tested on an ARCTIC F12 PWM PST.
Design aid: I got claude to help me with the OpenSCAD code and suggest features and parameters.
Parametric: the included OpenSCAD file exposes every dimension — outlet size (focus vs airflow), duct length, vane count/height, ring spacing (finger gap), fairing length, and wall thicknesses — so you can retune it for a different fan, focus level, or profile without CAD work. STL is provided ready to print.
Print notes: no supports needed
