K3NG Box remix for Nextion NX4024K032
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modified enclosure for a K3NG-based controller, converted from the original 5" Nextion display cutout to a 3.2" Nextion.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 30
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Modified enclosure for a K3NG-based controller, converted from the original 5" Nextion display cutout to a 3.2" Nextion Enhanced (NX4024K032) display.
This is a remix of the original K3NG box: the large 5" screen window and its mounting holes on the rear panel have been closed off, and a new opening sized for the 3.2" module has been added, along with four correctly-spaced mounting holes.
What changed
Old 5" window (≈119.6 × 78.7 mm) and its 4 mounting holes filled flush with the wall
New display window 81.7 × 48.4 mm (sized on the module's visible area + clearance), horizontal orientation, centered
4 × Ø3.4 mm mounting holes at the official NX4024K032 spacing (88.6 × 41.2 mm)
All other dimensions unchanged (216 × 136 × 100 mm), model is watertight and print-ready
Print settings (suggested)
Material: PETG recommended (better heat/UV resistance for an electronics enclosure), PLA also fine
Layer height: 0.2 mm
Walls: 3–4 perimeters
Infill: 15–20%
Supports: only needed for the connector/button openings depending on print orientation
Notes
The window is a clean through-cut with no rebate/lip. If you need a recessed step or standoffs for the display bezel, adjust before printing.
Mounting-hole positions were derived from the official Nextion dimensional drawing — please verify against your actual module with calipers before final print.
Designed for the Nextion Enhanced NX4024K032 (3.2"). Not tested with the Basic T032 variant, which has different active-area and hole dimensions.
