1 / 11
Century Graphic Lens Board - ILEX No. 3 Shutter / Barrel (1.913" x 40 TPI) (2x3 Baby Graflex) — image 1
1 / 11

Century Graphic Lens Board - ILEX No. 3 Shutter / Barrel (1.913" x 40 TPI) (2x3 Baby Graflex)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Mount an ILEX Acme No.3 Shutter or Barrel to a 2x3 Crown Graphic, Century Graphic or Baby Graphic.

Rating
0 / 5
Likes
6
Downloads
9
Makes
0
Views
118
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

A 3D-printable lens board for mounting an Ilex No. 3 Shutter or Barrel on a Baby Graphic / 2¼ × 3¼ Graphic camera.

Two versions are included:

  • A board for the factory original four-hole Ilex mounting flange

  • A board with the Ilex No. 3 mounting thread (1.913" x 40 TPI) printed directly into the board

The flange-mounted version offers the durability of the original metal thread, while the integrated-thread version is useful when a factory flange is unavailable.

Because the Ilex No. 3 is unusually large for a Baby Graphic, users should verify clearance around the shutter controls, rear lens cell, bellows, and front standard before use.

Application Notes:
- Print in Black or Matte Black filament. The Orange and Gray boards in the photo are there to better illustrate only.
- Bellow draw. The baby graphic has a bellow draw of 7¾ inches, or about 196 mm.  That might limit the focal lengths you can actually use on this camera. 

Factory Flange Version V2
Updated August '26
- Easier to print, Print camera side DOWN. No support, 45 Degree Bridge Angle.
- Improved hole alignment.
- Tested with Sunlu Matte PLA.
- Before going out to buy mounting screws, you might be able to salvage self tapping screws from inexpensive disposable electronics you already have.

Factory Flange Version V1
- Tested with PLA and PETG
- Print camera side up. 
- Before going out to buy mounting screws, you might be able to salvage self tapping screws from inexpensive disposable electronics you already have.

Threaded Version:
- Print camera side up
- 0.15mm layer height. The 40 TPI thread needs this.
- Use scarf joints and randomize seam positions.
- Avoid crossing perimeters.
- 15% Gyroid infill.
- The threads already has +0.012 clearence over nominal baked-in. Should thread-on with minimal resistance. If it feels tight, you might be cross-threading or you material might have too much shrinkage.
- Tested with PLA and PETG (Overture PETG worked good, Sunlu PETG shrank too much and the thread become too tight.)

Tags