Cable Clamp for screw mounting (Cable LS-FL 2x)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cable clamps for mounting onto wood surfaces, woodden beams or other soft surfaces. Suitable for LS-FL type cables.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 13
- Makes
- 0
- Views
- 49
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Just another cable clamp. I was struggling and also lazy to get these in the local hardware store and electrical supplies stores. So, I drew it up and printed plenty of them from PET-G due to the need for and flexibility. You can print them in minutes in any favorite color.
The clamps are to be fixed by 2.5x25 or 3x25 wood screws or longer. The hole is 3mm and after screwing, they are very hard break-off.
Printing Instructions:
Model files already face the clamping surface down (do not rotate!)
For print plate I recommend textured PEI plate (firm grip) or smooth plate
Print from PET-G, ABS or ASA
Infill: 50% or more
Perimeters: 3
No supports nor bridging neccessary
Brim is not needed if you have setup your 1st layer correctly and washed your plate with alcohol. Otherwise use brim 2-3mm but removing it on a couple of hundred pieces would be a pain...
If other dimensions are needed, let me know the cable size. If I am bored, I can draw-up some other clips round and oblong (UK) and possibly for fixing by hammer (using nails).