Door shelf/door bin for a Bauknecht refrigerator, model KGN 20C23IN
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Door shelf/door bin for a Bauknecht refrigerator, model KGN 20C23IN (may fit other Bauknecht refrigerators (untested))
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 45
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Public Domain
English version below
Konsole/Türeinsatz für einen Bauknecht-Kühlschrank vom Typ KGN 20C23IN
Könnte ggf. auch für andere (Bauknecht-)Kühlschränke passen (ungetestet)
Aus PETG gedruckt, weil es chemisch beständiger als PLA ist und bei bis zu 70 °C im Geschirrspüler ohne Verzug/Deformation gereinigt werden kann
Die Stützstrukturen sind ebenfalls aus PETG und lediglich die Schnittstellen zwischen der Konsole und den Stützstrukturen sind aus PLA
PETG und PLA sollten bestenfalls dieselbe Farbe haben, bspw. weiß oder transparent
Der Spülturm/der Abfall wird reduziert, weil das Spülen nach einem Filament-/Werkzeugwechsel als Infill in das Objekt gedruckt wird
Druckbar mit gewöhnlicher 0,4er-Messingdüse; keine gehärtete oder HF-Düse notwendig
Aufgrund des Filamentwechsels ist eine MMU3 notwendig (Extruder 1 = PETG, Extruder 2 = PLA)
English version
Console/Door shelf for a Bauknecht refrigerator, model KGN 20C23IN
Might also fit other (Bauknecht) refrigerators (untested)
Printed in PETG because it is more chemically resistant than PLA and can be cleaned in the dishwasher at up to 70 °C without warping or deformation
The support structures are also made of PETG, with only the interfaces between the console and the support structures made of PLA
Ideally, the PETG and PLA should be the same color, e.g., white or transparent
The purge tower/waste is reduced because the purge after a filament/tool change is printed into the object as infill
Printable with a standard 0.4 mm brass nozzle; no hardened or high-flow (HF) nozzle required
An MMU3 is required due to the filament changes (Extruder 1 = PETG, Extruder 2 = PLA)