1 / 6
SemiSmart PSU Holder for INBXX (US Version 44x71mm) — image 1
1 / 6

SemiSmart PSU Holder for INBXX (US Version 44x71mm)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

PSU holder to mount on INBXX (instead of C1), making use of predrilled holes on the back panel.

Rating
0 / 5
Likes
4
Downloads
13
Makes
0
Views
115
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

The cable for the PSU is not very long and is bulky.  I wanted a means to mount the PSU to INBXX instead of the Core One.  This mod is for the US version, but the EU version can be made using the included 3mf project file if needed.  I also added/bulked up the vertical columns on the vent holes present on the front and side to help reduce potential issues with bridging.

Each INBXX has a set of four holes on the left and right of the rear access panel, which are typically reserved for Semi-Smart.  This leaves 1 set (or 3 for Double INBXX) of holes that can be used to mount the PSU directly to INBXX.  The model will fit on either side of the rear access panel (see picture).  My intention was to use this on the bottom set on a Double INBXX.  If using on a Single, or the upper holes of a Double, the PSU will stand about 30mm above the top panel.

I used (https://www.printables.com/model/1243667-coreboxx-heated-semi-smart-add-on/files) Main_PCB_mount.stl as a guide to create the screw holes into the back of the model.  I also printed this and added heated inserts (same process as semi-smart guide) to mount the holder.  It's not required, as it should secure just fine using an M3 nut on the inside, but this offers a much nicer and secure fit.

I did NOT countersink the screws, so PAN HEAD screws are a must.  It will push against the PSU case a little, but it will still fit without issue.  I used 10mm on top and 8mm on the bottom, but either will work.

I included a test print file that you can print to verify hole alignment/shrinkage. Adjust for shrinkage if necessary.

Printed in ASA, using .20mm SPEED setting, 15% infill.
4x M3x8 or M3x10 (recommended) pan head screws
1x Main_PCB_mount.stl from semi-smart addon (used as a mounting aide)
4x M3 heatserts (if using PCB mount)

Tags