Scope Ring Mounts for 11mm Dovetail rail (1"/25.4mm Scopes)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ring-Mounts for 1" Scopes on Dovetail Rails. Height Base to Mid-Ring: 35mm Variants for Heat-Inserts, Square and Hexnuts
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 32
- Makes
- 0
- Views
- 212
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial
Couldn't get the mounting rings i wanted, at least not for a reasonable price, so i designed my own.
11mm Dovetail Mount as found on many air rifles and the like. On PCP / low power rifles the mounts are sturdy enough. Depending on the material you use, you can escalate to more demanding setups.
There is a marking on top to help with Scope alignment.
I designed this based on the rail on my Diana Mauser K98. When comparing, i found that these 11mm rails are not necessarily super standardized, so YMMV. The design accustoms for some variance, please let me know if you encounter problems.
Lightest variant is with heat inserts. Its designed for M3 short inserts (4x4mm holes) like from CNC-Kitchen.
My Hawke Vantage fits perfectly well with the 0 tolerance Top, but if you find your scope is loose, just pick another Top variant.
The M3 bolt lengths needed vary depending on the variant due to design-constraints, i built in wiggle room for length as much as possible while keeping a sleek design.
In all variants, there is also the possibility to use either a M3 grub screw or regular M3 bolt to secure against the top of the rail to further prevent creep along the rail if needed.
I printed in Prusament PCCF for maximum durability. Some pictures are taken of Prusament Galaxy Black prints for quick prototyping.
Orientation for printing works as provided without any supports, but don't let me get in your way!
Use manual seam painting if you want the best result.
Don't use PLA due to creep issues, otherwise use material according to your needs.
As orientation: In testing i used the following M3 bolt-head screw sizes (if not stated differently). Weights are just for comparison with same settings for all variants in PLA! Different nuts will... let's be honest - it doesn't matter.
Insert Variant | Hex-Nut Variant | Square-Nut Variant | |
|---|---|---|---|
Top | 4x M3x5 | 4x M3x6 | 4x M3x6 |
Clamp | 2x M3x5 | 2x M3x20 | 1x M3x10 1x M3x14 |
Retainer | M3x22 grub screw | M3x18 | M3x20 |
Weight | 15g | 19g | 17g |
After testing all 3, i personally like the Square-Nut version most. It offers the best compromise out of usability and sturdiness. But don't get mad at me if you lose a nut out in the field...