1 / 8
Compact Minimalist EDC Cash Wallet (US Currency) — image 1
1 / 8

Compact Minimalist EDC Cash Wallet (US Currency)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

An EDC cash wallet that has a compartment to put your coins after making a cash purchase.

Rating
0 / 5
Likes
1
Downloads
6
Makes
0
Views
55
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

An EDC cash wallet I made to solve the problem of where to put your coins after making a cash purchase. Every wallet I have ever seen, both mass-produced or 3D printed, never had a good place to put them even though if you make a cash purchase, you are bound to end up with coins. Your two options were to put them in your pocket and forget about it or just say "keep the change" and loose money. This wallet has a capsule, with a screw-on cap, in the middle to put coins. It fits a whole roll of unopened quarters and has space left over for two more loose quarters. It of course can hold other coins as the space is made for quarters since they are the largest coin currently in circulation. On the side there is an opening to put your US bills into a track which wraps around the coin compartment. To insert the bills, fold them in half and, holding by the fold, put them in short edge first into the slot. There is a small ridge at the opening to keep the bills from slipping out. This wallet can hold 1-7 circulated bills but even more if they are newer. The inside view of this wallet can be seen on my orange prototype in the last photo.

Comment any suggestions you may have to make this model better. I would love to take this model further.

Print settings I used:

  • 30% Gyroid infill

  • 5 Wall loops

  • No supports (To prevent slight drooping at the top of the cutouts, use slim tree supports.)

Post Printing: Carefully cut off any extra strands you may have on the threads before screwing the cap on. These are just a limitation of 3D printing and there is nothing to worry about since everything will work as intended. Screw the cap on and off multiple times to break in the threads. Push some folded bills in and out of the bill compartment to break up any stringing that might of occurred.

Behind the design:

I decided to make the bill track 3mm since I felt like 7 bills is a reasonable limit and I wanted to keep it tight enough to be able to hold even a single bill. I didn't make the bills go in a spiral because then the bills would be too curled up to use and a long, complex inside track would likely lead to jamming. I would also loose the friction that the folded bills create by expanding and they would just fall out. I didn't add any lanyard loop since the wallet can hold so much that either the loop would break off or be too uncomfortable to carry like that. I didn't add anything to keep the coins from rattling because they aren't going anywhere either way and there weren't any good solutions to add. If I added a spring to keep them in place, the whole thing would explode when opened. It would also add a lot of mechanical complications and it would stop being 100% 3D printed. It is also nice to be able to feel and hear how many coins you have left without needing to open the compartment. To minimize the cheap rattling sound I increased the infill to 30%.

Tags