1 / 4
Low Profile Wall Mount for Tapo C113, C216, C217, C236, C246D, — image 1
1 / 4

Low Profile Wall Mount for Tapo C113, C216, C217, C236, C246D,

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Wall mount made for sticking Tapo cameras. Uses the delicate arms. Differs to C200 mount. Locking latch is not modelled.

Rating
0 / 5
Likes
1
Downloads
61
Makes
0
Views
237
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

I needed a low profile mount to stick to my wall as a baby monitor.
I used two XL 3M command strips (removable velcro tape) to adhere to the wall.

I printed the mount out of some PLA+ at 5% infill and 80% infill around the little arm mounts.

Use support material under the arm mounts and they should clear away with little work.
I would also recommend using the height ranger modifier at level 2.0 to 5.4 to increase the resolution of the arms for a nicer finish.

Note: the locking latch is not modelled. I did this to keep the mount small and it wasn't required for hanging the C236 vertically.
I added stiffening borders in the model to improve strength where needed to prevent bending.

Tags