1 / 4
Low Profile Wall Mount for Tapo C113, C216, C217, C236, C246D, — zdjęcie 1
1 / 4

Low Profile Wall Mount for Tapo C113, C216, C217, C236, C246D,

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Wall mount made for sticking Tapo cameras. Uses the delicate arms. Differs to C200 mount. Locking latch is not modelled.

Ocena
0 / 5
Polubienia
1
Pobrania
61
Wydruki
0
Wyświetlenia
237
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I needed a low profile mount to stick to my wall as a baby monitor.
I used two XL 3M command strips (removable velcro tape) to adhere to the wall.

I printed the mount out of some PLA+ at 5% infill and 80% infill around the little arm mounts.

Use support material under the arm mounts and they should clear away with little work.
I would also recommend using the height ranger modifier at level 2.0 to 5.4 to increase the resolution of the arms for a nicer finish.

Note: the locking latch is not modelled. I did this to keep the mount small and it wasn't required for hanging the C236 vertically.
I added stiffening borders in the model to improve strength where needed to prevent bending.

Tagi