Gridfinity Plier Holder — 6× Gedore ESD Pliers (2×3×6)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Gridfinity 2x3x6 block holding six Gedore ESD pliers upright. Scalloped slots, open cavity, minimal support.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 20
- Makes
- 1
- Views
- 83
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
Gridfinity block that stands six Gedore ESD pliers upright in a drawer.
Each plier straddles both rows - one handle in the front row, one in the back so six pliers occupy twelve slots across a 2×3 gridfinity footprint.
Printing
It prints upside down. Set print_flip = true in the .scad, or just flip the model onto its top face in your slicer. That orientation is the whole trick: the top face goes down first and every wall stacks on top of it, so the shell itself needs no support at all.
Supports: on, one block only. The only thing needing support is the web across the middle of the base, which lands at the very end of the print. Use normal supports rather than tree — it's a single flat area. Once it's off the plate, reach in through the two open end bays and break the support out.
Everything else is either flat on the bed or at 45°.
Suggested settings:
0.2 mm layers - don't change this, the flare on the hole rims is built from 0.2 mm steps
3 walls, 4 top / 4 bottom, 15–20 % grid infill
No brim needed - the top face gives about 6200 mm² of bed contact
Customizing
The .scad exposes four parameters:
clearancefit around each handle — raise if tightheight_ublock height in 7 mm gridfinity unitstop_facethickness of the holed faceprint_flipstand it on its top face for printing
Requires https://github.com/BelfryDS/BOSL2) install it into your OpenSCAD library folder before opening the file. If you only want to print it, use the 3MF and ignore this.