1 / 14
26800 battery adapter for SkyRC MC3000 Charger — image 1
1 / 14

26800 battery adapter for SkyRC MC3000 Charger

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Adapter / cradle that allows charging 26800 and 21700 button-top / protected batteries.

Rating
0 / 5
Likes
5
Downloads
14
Makes
0
Views
68
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — NoDerivatives

This adapter allows you to charge longer batteries, namely 26800 and button-top 21700. These batteries are normally too long to fit in the slots of the SkyRC MC3000 Charger.

It can possibly work with other chargers. (Tested with XTAR DRAGON)

Warning - when batteries are charged in this adapter, the thermal monitoring and protection are not available - the thermal sensor is located in the actual charger slot, and the battery is being charged outside of this slot.

Print with Supports. PETG, ASA or ABS is highly recommended.

(!) Dont use PLA due to high temperature at high current charging and creep under tension.

Additional materials needed:

4x M3x8mm pan-head / (!) low-profile head machine screws

10 washers - used on both, head and nut side of the screws. with wire (lug) compressed between two washers and a washer right behind the screw head. Everything should be sandwiched with washer - Screw -> washer -> plastic part -> washer -> wire (or wire lug) -> washer -> nut,

2x M3 nuts + optional lock-washers

length of 1mm diameter (18AWG) tinned solid copper wire needed, cut and formed for each terminal connection. Use of soldered or crimped wire lugs is completely optional but recommended for good electrical contact.

Re-tighten the screws after a few days to take up any compression creep and ensure low-resistance electrical connection.

Tags