Konnected Alarm Panel Pro Case — Magnetic Mount (press-fit magnets)

A remix of zefer's Konnected Alarm Panel Pro Case that mounts magnetically inside a steel alarm enclosure: six 6×3 mm neodymium discs press-fit into pockets in the base.

Fit coupon included. Press fit depends on your printer, so print magnet_fit_coupon.stl first: four pockets at Ø6.10–6.40, dot-marked 1–4 (1 = tightest). Pick the snug-but-seatable one. Ø6.20 is the shipped STL; other diameters are a one-line change in the FreeCAD script.

Raised features on the enclosure wall (screw joints, rivets) keeping the magnets off flat steel? Stack a second disc on each magnet — self-aligning, ~2.6 mm more standoff per disc, full grip. The pictured install clears its screw joints this way.

STEP files, parametric FreeCAD build scripts, and design notes: https://github.com/zackgomez/konnected-magnetic-case

Designed and scripted in collaboration with Claude (Fable 5, via Claude Code) — geometry analysis, build scripts, and the coupon workflow were Claude's.

Print settings

• Both parts print flat as exported, no supports (pocket ceilings are short bridges)

• As pictured: ASA, 0.4 mm nozzle, 0.3 mm layers, ~30 g for base + lid. PLA at 0.2 mm works too, per the original

• Coupon prints as imported: pockets and dot marks face up

Assembly / hardware

• 6× neodymium disc magnets, 6×3 mm (mine calipered 6.03 × 2.64; no polarity concerns against steel)

• CA glue optional — press fit alone holds mine; add a drop per pocket if magnets stay on the wall when you pull the case off

• Board mounting per the original: 4× M3 nuts, standoffs (e.g. M3 6+6), M3 screws; lid screws M3×6