Servo centering gauge for KST X20-2208 and MKS HBL880
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Slide-on gauge that shows the shaft axis. Set a servo's neutral with the programmer. KST X20-2208, MKS HBL880.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 26
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
A small gauge that slides onto a standard-size servo and puts a 1 mm slot right over the output shaft axis. Fit a horn, trim the neutral with the programmer until the horn lines up with the slot, done. No ruler, no squinting at the case edge.
Supported servos: KST X20-2208 (shaft axis 10.35 mm from the case end) and MKS HBL880 (10.0 mm). Both have a 40 x 20 mm case, but the axis offset and the case height above the flange differ, so each servo gets its own STL. The variants look the same, so the servo name and L/R are engraved on the cross bar.
Note: Unfortunately the MKS HBL880 is not programmable, so the gauge is not that useful for that servo.
How to use
Slide the fork sideways onto the 40 mm side of the case, below the mounting flange, until the stop face touches the case.
Push the gauge up against the underside of the flange.
Press the arm marked with the arrow against the end of the case nearest the shaft. All the play sits on the other arm, so the slot is now on the axis.
Fit a horn and trim the neutral with the programmer (for the KST that is the Servo Programming Tool Card #3) until the horn lines up with the slot and the pointer tip.
L and R
The pointer only rises on one side, so the gauge cannot be flipped over. L has the pointer near the left arm when you look from above with the pointer pointing away from you, R is the mirror image. Which one you need depends on which side of the servo you slide it on from. Print both, each is about 8 g of filament.
Printing
Flat on the bed, no supports. The pointer underside is a 45 degree overhang.
0.4 mm nozzle, 0.2 mm layers. The two fins beside the slot are 2 mm wide.
PLA or PETG.
The fork is designed with 0.15 mm total clearance on the 40 mm case. If it binds on your printer, raise the fit parameter in the OpenSCAD file and re-export.
Files
servo_center_tool_KST_X20_2208_L.stl and _R.stl
servo_center_tool_MKS_HBL880_L.stl and _R.stl
servo_center_tool.scad, the OpenSCAD source. Servo and L/R are Customizer dropdowns.
Adding another servo is one row in the servos table: case length, shaft axis distance from the shaft-side end of the case, and case top height above the flange underside. Read them off the drawing or measure with calipers.
Dimensions used
KST X20-2208: case 40 mm, axis 10.35 mm from the case end (17.85 from the flange edge minus 7.5 overhang, per datasheet), case top 11.7 mm above the flange underside.
MKS HBL880: case 40 mm, axis 10.0 mm from the case end, case top 10.2 mm above the flange underside. Both measured on the servo.