Articulating INDX Top Hat PTFE tube Grommet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Articulating grommet for the PTFE tubes on the C1 INDX top-hat
- Rating
- 5 / 5
- Likes
- 60
- Downloads
- 96
- Makes
- 1
- Views
- 1,313
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A solution to close up the holes in the stock top hat for the C1 INDX.
You will need to drill out the existing PTFE holes to 14mm. Most Step drills will have a step at 14mm.
Be warned, the tolerances on this are very tight. there is
0.15mm clearance around the ball
0.125mm clearance in the threads. The threads are quite a fine pitch as well.
0.3mm clearance around the PTFE tube.
I recommend printing the ball at a very fine layer height.
Based on my preliminary testing, the ball will perform better if it is printed at a different layer height than the holder to help avoid the layer lines "meshing."
A note about seams:, Random, and Scarf Seams everywhere.
If your filament is well calibrated, you should not have any troubles, the imaged models are printed at 0.2mm layer height with a 0.4mm nozzle, They perform well enough, but a smaller layer height on the ball would be better.
