1 / 4
Ingenic A1 NVR Case (NG board) - Compact, Snap Fit, Screwless SSD Tray — image 1
1 / 4

Ingenic A1 NVR Case (NG board) - Compact, Snap Fit, Screwless SSD Tray

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Half the size of the original. Stacked 2.5in SSD tray, no screws, snap fit lid. Parametric OpenSCAD.

Rating
0 / 5
Likes
0
Downloads
4
Makes
0
Views
32
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Share Alike

A compact enclosure for the Ingenic A1 NVR board (NG variant, 130 x 50 mm) with a

2.5 inch SATA SSD mounted above it.

## Why it is smaller

The original lays the board and the drive side by side, so more than half the footprint is empty air. This version stacks the drive on a shelf in the space that was already being wasted above the tall connectors.

- Outer size 142.8 x 83.8 x 42.8 mm

- 512 cm3 against roughly 1091 cm3

- 120 cm2 of desk against roughly 237 cm2

## Screwless SSD tray

The drive slides in from the cable end and clicks into place. Two sprung fingers drop into the M3 side holes, and a pair of chamfered lips hold the top face.

- No screws, no zip ties, no rubber grommets

- Pull the drive to release, roughly 7 N, no tools

- Tray prints flat so the fingers flex along the layer lines, not across them

- Fits 7 mm drives, set one variable for 9.5 mm

## Snap fit lid

Six 45 degree ribs on the lid skirt drop into matching grooves in the base. The wall itself is the spring, so there are no thin cantilever latches to snap off.

Two pry tabs let you pop it open by hand. Closing the lid also clamps the drive tray, which is why the tray needs no fasteners of its own.

## Cooling

Vents are in the lid and the rear wall only. The floor and both end walls stay solid for stiffness and to keep dust out.

The drive shadows most of the lid, so the airflow path is deliberately sideways at board level, entering through the front panel openings and leaving through the rear honeycomb, directly opposite. Hexagons are used because they tile, giving about 68 percent open area against 54 percent for a circle grid on the same pitch.

## What you need

- 3 x M3 pan head self tapping screws, 6 to 8 mm

- 4 x stick on rubber feet, recesses are provided

- A right angle SATA data and power cable

Note the right angle cable. There is 20 mm of clearance at the drive connector, which is plenty for a 90 degree plug but not enough for a straight one. Increase the cable_gap variable in the SCAD file if you only have straight cables.

## Printing

- 3 parts, no supports needed on any of them

- 0.4 mm nozzle, 0.2 mm layers, 4 perimeters

- PETG preferred, it takes more strain than PLA so the snap fingers last longer

- PLA, ABS and ASA all work

Print the base open side up, the lid top face down, and the tray flat. The STLs are already in those orientations.

## Parametric

The OpenSCAD source is included. Board dimensions, connector positions, drive thickness, wall thickness, vent size and all clearances are variables at the top of the file. Set the part variable to base, lid, tray or printplate to export.

Tags