Lotus lamp (LED lamp kit / tealight / mini LED)

The design is available in three variants:

1. Large - LED Lamp Kit: The original full-size version, designed for a proper LED lamp module. Best print quality and overall lighting experience.

2. Medium - LED Candle / Mini LED: A smaller version compatible with either an LED candle or the Mini LED. The LED candle produces a subtle, dim glow, while the Mini LED provides a much stronger and more dynamic lighting effect.

3. Small - Mini LED: The smallest version, designed specifically for the Mini LED. Its remote-controlled RGB lighting creates excellent effects, but the reduced scale results in slightly less consistent petal wall thickness and therefore somewhat lower print quality.

Components:

• LED Lamp Kit: https://s.click.aliexpress.com/e/_c35o89iR

• LED Candle: https://s.click.aliexpress.com/e/_c3TvVY4n

• Mini LED: https://s.click.aliexpress.com/e/_c4oI8LaX

Assembly:

• Medium and Small: Simply place the LED light underneath the lamp's internal opening.

• Large: Insert the LED module into its slot, then press the cable firmly into the cable cutout. The cable locks the LED module securely in place. (Like shown below)

Printing:

Use my shared, pre-configured 3MF print files or do the following setup:

• 0.40mm nozzle

• 0.20mm standard profile

• 0% global infill

• Ensure vertical shell thickness: disabled

• Split the geometry into parts, position the ‘core’ part at the bottom of the hierarchy and set its wall loop count to 3 and the infill to 15% gyroid

• For the Large variant only set up Height range modifiers to avoid wobbling at the higher layers:

  • 86.6-123.4mm: inner and outer wall speed: 50mm/s

  • 123.4-200mm: inner and outer wall speed: 30mm/s

Commercial License:

You can subscribe for a commercial license membership on my Patreon.