Zombie Mechanic
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Zombified Mechanic, Dead and still grinding to get his work done. Produced with the help of AI.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 8
- Makes
- 0
- Views
- 32
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Sculptures
- License
- Creative Commons — Attribution
Here is a Zombie Mechanic. ready to print.
I printed with a 0.6 nozzle, just because that's where I do most of my work, and I keep these small figure prints for time wasters, I think they are fun, but my detail dropped of due to the larger nozzle size.
I would recommend a 0.4 or smaller if you want great detail, Low wall count, low infill doesn't need any great amount of specific settings. Supports are a necessity.
Model feet are not quite level to the upright figure. If you want to have it stand up properly, I suggest cutting off the bottom at least 0.5, I printed mine with about 0.9 cut off the feet, just to give a nice flat surface, I'm not going to be looking for detail in the bottom of the boots.