Air Freshener Holder for VW T-Roc (2018-2026) - Air Vent Clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Air Freshener Holder that clips into the air vent of a VW T-Roc (2018-2026).
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 31
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
Air Freshener Holder that clips into the air vent of a VW T-Roc (2018-2026).
Holds a felt pad or a scented stone in a vented chamber. The six slots are not decoration: an air freshener with a closed body does not blow through and stops smelling after a day.
You need: a felt pad 26-28 mm, or a scented ceramic stone. Add a few drops of oil, drop it in, clip it on.
FITMENT
This car has rectangular vents with HORIZONTAL blades, so the clip is the sprung-jaw type: it grips a blade 1.2-3.2 mm thick and up to 16 mm deep, with friction teeth inside the jaws.
The jaw is deliberately sprung rather than a fixed slot, because real vent blades vary between cars and even between the left and right vent of the same dashboard. If it ends up tight, it is meant to be - it holds by friction and should need a firm push.
MATERIAL - THIS ONE MATTERS
Print in PETG or ASA. Not PLA. A parked car in the sun goes past 60-70 C inside, and PLA starts to soften around 55 - a PLA clip will sag off the vent, taking whatever it was holding with it. This is not a preference, it is the condition for the part working at all.
Settings: 0.2 mm layers, 4 perimeters, 30% infill, no supports. Print as oriented - the whole part is one extruded profile lying on a flat face, and the spring jaw bends in the plane of the layers, which is the only orientation that survives repeated clipping.
Not affiliated with, endorsed by, or connected to any vehicle manufacturer. Brand and model names describe fitment only.
