Whetstone case for KEENBEST 400/1000 + 3000/8000 set with bamboo base
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for the KEENBEST whetstone set: stones with drains below, bamboo base, flattening stone and angle guide in a tray.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 19
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
Storage case for the KEENBEST 400/1000 + 3000/8000 whetstone set with bamboo base: https://www.amazon.de/dp/B09FL3LY51
Holds everything except the leather strop, each part in its own pocket with 1 mm clearance so nothing bounces around:
Both stones, sitting in their rubber frames, in the bottom of the case, with the flattening stone standing in its own socket across the end. Drain slots straight through the floor under each and vent slots in the walls, so they can dry.
The bamboo base and the angle guide in a lift-out tray with a solid floor above the stones, so drips never reach the bamboo.
Shoebox lid with vent slots.
Three parts, all print flat without supports on a 250 x 210 bed:
case.stl: 238 x 150 x 63 mm
tray.stl: 228 x 140 x 25 mm
lid.stl: 244 x 156 x 15 mm, exported top face down, print as is
Everything can be tilted out with a finger: the stone layer is open above the rubber frames, the tray cavity and the lid skirt are flared so they lift one side first without jamming, and the base and guide have finger notches and a scoop.
Test-fit gauges, print these first (about 40 g in total):
gauge-holder, gauge-base, gauge-flat, gauge-guide: thin frames with the pocket outline, stepped inside at 0.5 / 1.0 / 1.5 mm clearance per side. Press the item down: it should reach the bottom step. If it sits on a higher step, the item is bigger than the case expects.
gauge-stack: a bridge with 35 mm inner height. Stand it over a stone sitting in its rubber frame; it must clear.
Item sizes used, all measured on the real set: stone 178 x 58 x 26, rubber frame 184 x 65 x 12, bamboo base 221 x 92 x 21, flattening stone 60 x 30 x 30, angle guide 99 x 20 x 20.
Print settings: PETG recommended since the stones go in wet. 0.2 mm layers, 3 perimeters, 15 to 20 % infill.
Status: a first case was printed with a narrower frame socket and did not fit; this version has the measured sizes and is not yet printed. Let the stones dry before putting them away.
