1.5mm Charger Bullet Lead Strain Relief
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This helps solve the problem of the broken solder joint on the 1.5mm balance lead connectors.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 1
- Makes
- 0
- Views
- 12
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — NoDerivatives
This strain relief/holder will allow you to grip and pull the bullet plug out of the battery without putting the strain on the cable. The interface of the plug to the holder is mechanical when being pulled so you are gripping the bullet only.
Instructions:
Cleanly solder a fresh bullet to your cable, make sure you don't have a mess of solder. The tolerance is such that the bullet will just slide into the holder.
Slide the bullet into the holder, use something thin like tweezers to push it down if you have issues.
Pull it all the way through so the plug is fully seated in the holder.
Apply CA as shown, or use any other adhesive. Super-X also works great.
Allow to dry. The glue is mostly to hold the bullet in place when inserting, there is nothing stopping the plug from backing out.