Winix Air Purifier Hinged Light Cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Print-in-place hinged cover that blocks bright Winix air-purifier lights and flips up for easy control access.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 15
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
Winix Air Purifier Hinged Control-Panel Light Cover
This print is a simple hinged cover designed to block the bright control-panel lights on a Winix PlasmaWave air purifier 5300-2 without preventing access to the controls. It is especially useful when the purifier is used in a bedroom or other dark room.
The narrow upper strip attaches above the control panel using double-sided tape. The larger panel hangs down over the illuminated area and can be lifted using the small finger tab at the bottom. The hinge is printed in place, so no pins, screws, or assembly are required.
Dimensions
Cover panel: 120 × 53 × 2 mm
Mounting strip: 120 × 9 × 2 mm
Overall design includes a print-in-place hinge
Bottom-center lifting tab
Recommended print settings
Material: PLA
Nozzle: 0.4 mm
Layer height: 0.20 mm
Supports: None
Assembly: None
Print orientation: Print flat in the supplied orientation
Brim: Usually unnecessary
The hinge uses 0.50 mm of radial clearance to make it easier to free after printing and allow smoother movement. After removing the print from the build plate, gently work the hinge back and forth until it moves freely.
Attach the 9 mm mounting strip with thin double-sided tape, taking care not to cover vents or interfere with the purifier’s controls.
Designed around a 120 × 53 mm illuminated control area. Check the measurements of your purifier before printing, since control-panel dimensions may vary between Winix models.