1 / 5
LSI 9305-16e Fan Shroud (40mm) — image 1
1 / 5

LSI 9305-16e Fan Shroud (40mm)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A simple blow through type fan shroud intended for a 40x28mm server fan, but any thickness can be used.

Rating
0 / 5
Likes
0
Downloads
7
Makes
0
Views
76
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution

Intended to be printed upside down as shown.

Supports recommended. PLA or PETG recommended as you need to stretch it a bit to install. No special print settings needed.

Requires 4x M3 screws and 4x M3 nuts. Screws need to be the thickness of your fan plus at least 5mm but no more than 10mm (mounting face is 5mm thick and there is an additional 5mm gap between it and the heatsink), so for a 28mm thick fan 35mm screws work perfect.

To install:

  1. Slide the cover over the bottom side of the card along the edge of the PCB so the PCB is inside of it's slot

  2. Once fully slid on to where the retaining pin is where the hole in the back edge of the board is, fold the shroud over to cover the board and heatsink

  3. Finally, carefully stretch the top side slot over the edge of the board to capture the top of the board in it's slot, being careful not to fold over the foot of the slot

  4. Once installed the shroud should be fully constrained with just a small amount of wiggle from the retaining pin being slightly undersized

  • If you want an easier time just sliding the shroud straight on and off, you can snap off the retaining pin after printing, but there will be nothing but the friction of the PCB against the slots to keep it in place.

F3D and STEP included for ease of remix. Fair warning, the F3D is a bit of a mess. I had to roll back and fix mistakes a few times and then fix errors as I rolled back forwards to where I was, after a couple times I got sick of it and just modified it how I needed with about 900 extrudes.

Tags