1 / 8
Jumper T-Lite / T-Lite V2 Wall Mount for Honeycomb Storage Wall (with Happymodel ELRS module) — image 1
1 / 8

Jumper T-Lite / T-Lite V2 Wall Mount for Honeycomb Storage Wall (with Happymodel ELRS module)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Wall mount for the Jumper T-Lite radio, designed for the Honeycomb Storage Wall (HSW) system.

Rating
0 / 5
Likes
0
Downloads
0
Makes
0
Views
16
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Wall mount for the Jumper T-Lite radio, designed for the Honeycomb Storage Wall (HSW) system.

The center cutout clears the external Happymodel ExpressLRS module, so the radio hangs with the module installed and the USB-C port stays accessible.

PARTS

- Base.stl x1

- Left.stl x1

- Right.stl x1

HARDWARE

- 4 x M3 x 8 mm screws, zinc-plated (countersunk)

- 4 x M3 brass heat-set inserts

PRINT SETTINGS

- 0.2 mm layer height

- 2 perimeters

- 25% cubic infill

- Supports: needed for Left.stl and Right.stl (rounded overhang on the outer face). Base.stl prints without supports.

- PLA / PETG

IMPORTANT - INFILL MODIFIER ON Base.stl

Add a rectangular modifier box over the joint where the vertical back plate meets the horizontal shelf and set the infill to 50% inside it. That corner carries the whole weight of the radio - stock 25% infill there is the weak point. See the last image for the placement.

License: CC BY-NC-SA. If you print it, a photo in the Makes is always appreciated.

Tags