1 / 3
Grow Tent 16mm to 1/2" EMT Crossbar & Support Adapter — image 1
1 / 3

Grow Tent 16mm to 1/2" EMT Crossbar & Support Adapter

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Add vertical or horizontal 1/2" EMT supports to 16 mm grow-tent frames. Includes 90° and 120° angled adapters.

Rating
0 / 5
Likes
2
Downloads
4
Makes
0
Views
25
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Add custom horizontal or vertical supports to a 16 mm grow tent frame using standard 1/2" EMT conduit.

These adapters allow you to cut inexpensive, readily available 1/2" EMT to the length you need and snap the completed support directly onto the existing 16 mm grow-tent tubing.

Use them to add horizontal crossbars, vertical supports, or additional framing for lights, fans, sensors, cameras, cable management, environmental monitoring equipment, or simply to add more structure to your grow tent.

Each support requires two printed adapters and one piece of 1/2" EMT conduit.

Two Adapter Styles

Two versions of the adapter are included:

90° / Perpendicular Adapter

The EMT is positioned perpendicular to the existing 16 mm tubing. This version can be used for both vertical and horizontal supports and is ideal anywhere a standard 90-degree connection is needed.

Angled Adapter – Approximately 120°

This version positions the EMT at approximately a 120-degree angle relative to the existing 16 mm grow-tent tubing.

The angled version is designed primarily for horizontal installations, where the geometry of the grow-tent frame makes an angled connection more appropriate.

Important: When installing the angled adapter horizontally, orient the adapter with the extended/long side facing UP. The side of the clip that extends farther past the 16 mm tube is the top of the adapter. See the photos for the proper orientation.

Installation

  1. Measure the distance between the two existing 16 mm grow-tent tubes where the new support will be installed.

  2. Cut the 1/2" EMT approximately 3/8" shorter than the measured distance.

  3. Insert one printed adapter onto each end of the EMT.

  4. Snap the completed EMT and adapter assembly onto the existing 16 mm grow-tent tubing.

For the 120° angled adapters, make sure the extended/long side is facing UP when used for a horizontal support.

No drilling or modification of the original tent frame is required.

The same basic installation method can be used to add both vertical and horizontal supports.

Strength Testing

note: Only tested PLA.
Each adapter was tested with up to approximately 40 lbs of load/stress per clip before failure.

This testing is provided as a reference and should not be considered a rated working-load specification. Actual strength will vary depending on filament type, print settings, layer adhesion, print orientation, temperature, and the direction of the applied load.

Print Settings

Materials: PLA, PETG, ASA or ABS
Layer Height: Tested at 0.16 mm and 0.20 mm
Infill: 15% Gyroid, or print solid if preferred
Supports: None required

Filament Condition

For best results, make sure your filament is dry before printing. Moisture-contaminated filament can result in poor layer adhesion and weaker, more brittle finished parts. This is particularly important for snap-fit clips and other parts that must flex during installation.

If a printed model seems unusually brittle or breaks easily when being snapped onto the tubing, check and dry your filament before assuming the model needs additional strength or infill.

Revision Note:

I purchase some additional conduit and found that the tolerance on the actual conduit is off.
The original support adapters would not fit however they worked fine with the conduit I purchase a few months ago.  I modified the adapters to allow for a looser fit. 

Tags