SV08 Fornuftig top holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
If you have the official SV08 enclosure, with this you can put the IKEA Fornuftig air filter on top!
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 27
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
If you have the official SV08 enclosure, you can replace the top front panel with an Ikea Fornuftig air filter!
The width of the filter case is practically the same as the width of the top front panel and this model should prevent it from falling in.
The Fornuftig case can contain both a normal air filter + a carbon filter but they are usually sold without the carbon filter.
Printing:
Use something that can withstand the heat in the printer chamber. I used PETG but I generally keep the temperature inside quite low.
No supports needed, just orient it with the 'notches' facing down. I added those to prevent warping.
Use at least 3 wall loops. I used gyroid infill to try and avoid warping. (Not entirely successful but it could be a lot worse.)
Try at your own risk!