Hand Grip for Pentax K1000 Film Camera
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Found a K1000 during my travels, fixed it up and made a handgrip for it
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 15
- Makes
- 0
- Views
- 102
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Like all cameras from the 70s, ergonomics were not the primary concern behind making a body that would last for decades and that was aggresively priced to be a general everyman device. The Pentax K1000 was produced between 1976 and 1997; a 21 year production run! This was the peak of the film camera era and the K1000 survived without all the fancy bells and whistles afforded by electronic controls or integrated circuitry. This fully-mechanical camera (which included - but does not require to function - a match-needle light meter built-in) had approximately 3 million examples put out into the wild during this prolific production run, many of which are still being used today by film students and people who appreciate the grab-and-go ease of a device that does not need batteries.
I found one of these at my local thrift and I just could not pass it up. Needed a little oil and new light seals. Otherwise it was in very good condition, but was lacking all optional accessory pieces (strap rings, eyecup, etc...). I have a 3D printer so went looking for whatever I could find to print for this new toy. Surprisingly, there is not a lot of stuff out there (only 2 results for "Pentax K1000" on Printables) for a camera with so many units and such a long production run. So here we are. A Handgrip for an iconic camera, provided for free with the original FreeCAD files if someone else wants to take a crack at making improvements or resizing for differently-sized hands.
There are 2 different versions of this grip. One with, and one without a separate hole for a 1/4-20 X 8mm Lg. heat-set insert so you can use a tripod while the grip is still attached; although it is not centered around the lens path, it is still on the same plane as the original tripod socket. Print with the bottom side against the build plate and use supports for the 2 flat surfaces not against the plate. You will probably have to reorient the model in your slicer, but that's the price you pay for free models.
You will need some hardware for this grip, but it's easy to get:
1X Folding Thumbscrew (Amazon link to the exact one I used, however the d-ring is not kept very tightly and can sometimes fall down and make the grip not lay flat when placed on a table)
1X 7/32" or 5mm e-clip to retain the thumbscrew in the grip so it won't fall out and get lost when the grip is removed (Amazon link or a cheaper and more immediate option Home Depot link)
OPTIONAL 1X 1/4-20 x 8mm x 8mm heat set insert (Amazon link)