DIY Air Purifier: 4-Fan Top for a Xiaomi HEPA Filter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A printed top plate that turns a round Xiaomi air purifier filter into a DIY purifier with four 70 mm fans.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 84
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple way to build an air purifier from a replacement Xiaomi HEPA filter: this round plate sits on top of the filter and carries four 70 mm fans that pull air through it.
How it works
The plate (Ø201 mm) sits on the filter: a thin 8 mm rim goes around the filter's edge and a ring underneath centres it on the filter's top seal.
Four openings (Ø67 mm) for 70 mm fans, each with four holes (Ø2.9 mm) for self-tapping screws.
The fans blow upwards, so air is pulled in through the sides of the cylindrical filter.
Which filter fits
Designed and tested with the filter for the Xiaomi Mi Smart Air Purifier 4 Lite (original M17-FLR; I used the compatible Filtero FTA 07). The rim fits filters up to Ø199 mm, so other round Xiaomi filters may fit too — measure the outer diameter of yours before printing.
Bill of materials
1× Xiaomi Mi Smart Air Purifier 4 Lite filter (M17-FLR or a compatible one, e.g. Filtero FTA 07)
4× 70 mm 12 V fans — I used Delta AFB0712HHB
16× M3 × 10 self-tapping screws
12 V 2 A power adapter — check the current on your fans' labels: the four together must stay below the adapter's rating
Lever wire connectors (Wago) to join the fan wires
Assembly
Screw the four fans to the plate with M3 × 10 screws so that they blow upwards, away from the filter.
Join the fans' power wires in parallel (red to red, black to black) with lever connectors and connect them to the 12 V adapter. The yellow/blue tach and PWM wires are not needed.
Put the plate on the filter and plug it in.
Tip: I run the fans directly from 12 V, without a speed controller. The Delta AFB0712HHB is a high-speed fan — powerful, but noticeably loud at full speed. If you want it quieter, add a PWM fan controller or a 12 V DC speed regulator, or use quieter 70 mm fans.
Print settings
Printer: QIDI Q1 Pro, nozzle 0.4 mm
Material: ABS (47.7 g, ~3 h)
Layer height: 0.2 mm
Walls: 2, top layers: 6, bottom layers: 3
Infill: 15 % adaptive cubic
Supports: none — print it with the flat top face on the bed and the rim pointing up
The part is Ø201 mm — it needs a bed of at least ~205 × 205 mm
