1 / 1
DIY Air Purifier: 4-Fan Top for a Xiaomi HEPA Filter — zdjęcie 1

DIY Air Purifier: 4-Fan Top for a Xiaomi HEPA Filter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A printed top plate that turns a round Xiaomi air purifier filter into a DIY purifier with four 70 mm fans.

Ocena
0 / 5
Polubienia
1
Pobrania
6
Wydruki
0
Wyświetlenia
84
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A simple way to build an air purifier from a replacement Xiaomi HEPA filter: this round plate sits on top of the filter and carries four 70 mm fans that pull air through it.

How it works

  • The plate (Ø201 mm) sits on the filter: a thin 8 mm rim goes around the filter's edge and a ring underneath centres it on the filter's top seal.

  • Four openings (Ø67 mm) for 70 mm fans, each with four holes (Ø2.9 mm) for self-tapping screws.

  • The fans blow upwards, so air is pulled in through the sides of the cylindrical filter.

Which filter fits

Designed and tested with the filter for the Xiaomi Mi Smart Air Purifier 4 Lite (original M17-FLR; I used the compatible Filtero FTA 07). The rim fits filters up to Ø199 mm, so other round Xiaomi filters may fit too — measure the outer diameter of yours before printing.

Bill of materials

  • 1× Xiaomi Mi Smart Air Purifier 4 Lite filter (M17-FLR or a compatible one, e.g. Filtero FTA 07)

  • 4× 70 mm 12 V fans — I used Delta AFB0712HHB

  • 16× M3 × 10 self-tapping screws

  • 12 V 2 A power adapter — check the current on your fans' labels: the four together must stay below the adapter's rating

  • Lever wire connectors (Wago) to join the fan wires

Assembly

  1. Screw the four fans to the plate with M3 × 10 screws so that they blow upwards, away from the filter.

  2. Join the fans' power wires in parallel (red to red, black to black) with lever connectors and connect them to the 12 V adapter. The yellow/blue tach and PWM wires are not needed.

  3. Put the plate on the filter and plug it in.

Tip: I run the fans directly from 12 V, without a speed controller. The Delta AFB0712HHB is a high-speed fan — powerful, but noticeably loud at full speed. If you want it quieter, add a PWM fan controller or a 12 V DC speed regulator, or use quieter 70 mm fans.

Print settings

  • Printer: QIDI Q1 Pro, nozzle 0.4 mm

  • Material: ABS (47.7 g, ~3 h)

  • Layer height: 0.2 mm

  • Walls: 2, top layers: 6, bottom layers: 3

  • Infill: 15 % adaptive cubic

  • Supports: none — print it with the flat top face on the bed and the rim pointing up

  • The part is Ø201 mm — it needs a bed of at least ~205 × 205 mm

Tagi