Shim/adapter for 800 mm f/8 to adapt to 69 mm lens foot
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows for the cheap catadioptric 800 mm f/8 lens to be mounted on a 69 mm lens collar + foot. Wallimex/Rokinon/Samyang.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 12
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Share Alike
The 800 mm f/8 is a cheap and quirky catadioptric lens with a T2 mount that can be easily adapted to most camera mounts. It's sold under the Wallimex / Rokinon / Samyang brands.
To mount it on a tripod it really needs a lens foot. Unfortunately the geometry in the back is not very helpful. There is a 68mm radius protrusion, but it's only about 7.5 mm wide.
I managed to buy a cheap "close enough" lens foot with a 69 mm (nice!) collar diameter. The 1 mm difference and slim shoulder made it super prone to move or slip out though, even when shimmed with some tape.
Today I realized that I could address this with a 3D printed part. I threw up a extremely simple model in CAD and after adjusting fillets it fits perfectly. The T2 adapter holds the shim in place, even though it wouldn't be necessary as it is a snug press fit. (Depending on printer scaling up slightly might be required)
Final print is out of black PETG. Photos are of a PLA test print, as it's easier to see.
Beware: If you want to go in this direction, the knock-off Nikon RT-1 foot that I bought was too shallow for this lens. I had to grind off at least 2 mm of the upper side of the bottom plate to make it fit. Ideally one would go straight to a lens collar that can accommodate the 108-109 mm lens diameter, or 20mm distance between collar and plate.