1 / 3
Shim/adapter for 800 mm f/8 to adapt to 69 mm lens foot — zdjęcie 1
1 / 3

Shim/adapter for 800 mm f/8 to adapt to 69 mm lens foot

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows for the cheap catadioptric 800 mm f/8 lens to be mounted on a 69 mm lens collar + foot. Wallimex/Rokinon/Samyang.

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
12
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Share Alike

The 800 mm f/8 is a cheap and quirky catadioptric lens with a T2 mount that can be easily adapted to most camera mounts. It's sold under the Wallimex / Rokinon / Samyang brands.

To mount it on a tripod it really needs a lens foot. Unfortunately the geometry in the back is not very helpful. There is a 68mm radius protrusion, but it's only about 7.5 mm wide.

I managed to buy a cheap "close enough" lens foot with a 69 mm (nice!) collar diameter. The 1 mm difference and slim shoulder made it super prone to move or slip out though, even when shimmed with some tape.

Today I realized that I could address this with a 3D printed part. I threw up a extremely simple model in CAD and after adjusting fillets it fits perfectly. The T2 adapter holds the shim in place, even though it wouldn't be necessary as it is a snug press fit. (Depending on printer scaling up slightly might be required)

Final print is out of black PETG. Photos are of a PLA test print, as it's easier to see.

Beware: If you want to go in this direction, the knock-off Nikon RT-1 foot that I bought  was too shallow for this lens. I had to grind off at least 2 mm of the upper side of the bottom plate to make it fit. Ideally one would go straight to a lens collar that can accommodate the 108-109 mm lens diameter, or 20mm distance between collar and plate.

Tagi