1 / 2
IKEA MULIG Rod Wall Mount Rod Holder for Cut-Down Bars (18x30 / 13x25 mm) — image 1
1 / 2

IKEA MULIG Rod Wall Mount Rod Holder for Cut-Down Bars (18x30 / 13x25 mm)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Wall brackets to reuse the cut-down rectangular bars of an IKEA MULIG clothes rack as a closet rod between two walls.

Rating
0 / 5
Likes
0
Downloads
2
Makes
0
Views
9
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

I wanted to use the bars of an IKEA MULIG clothes rack as a hanging rod in a niche between two walls.
The original bars are longer than the gap between the walls, so I cut them down to length with a saw. That leaves raw, open ends that no longer fit the MULIG connectors – so I designed these wall brackets.

The bar drops in from the top into an open U-shaped cup, and you can lift it out again without tools. A 45° support underneath carries the load, and all the edges are rounded so it looks good on the wall.

Two sizes included:

  • rod_holder_large_18x30mm.stl – for the 18 x 30 mm bar

  • rod_holder_small_13x25mm.stl – for the 13 x 25 mm bar

The bars sit upright (long side vertical) so they bend as little as possible under load. There is 0.4 mm of clearance on each side, and the bar sits 20 mm deep in the cup.

Mounting:

  • 2 countersunk screws per bracket, 5 mm (one above the bar, one below the support)

  •  Use wall plugs that suit your wall

  •  Measure the gap before cutting, and cut the bar about 1–2 mm shorter so it drops in easily

Print settings:

  • Flat back on the bed, cup facing up – no supports needed

  •  PETG recommended (PLA works for light loads)

  • 0.2 mm layers, 4 walls, 30–40 % infill

Tags