Canyon Grizl Fork GoPro Mount Helper PETG (tested on 45 - 50 km rough terrain in a single ride)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Designed for the "Canyon FK0143 CF" fork (Canyon Grizl CF 8 Di2)
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 7
- Makes
- 0
- Views
- 307
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed for the Canyon Grizl CF 8 Di2, but should work with the similar CF/Al forks.
I created this mount because I wanted to take low angle cycling videos with my GoPro Hero 9, but unable to clamp safely onto the carbon fibre body of the fork.
To be used with the official GoPro tube mount. I understand that I could have 3D-printed the whole mount for the sake of 3D-printing. But it's more pragmatic to design it as a helper for the official mount which allows free rotation, thus more filming angles horizontally and vertically.
Stress-tested in forest trails, gravel roads, cobblestones, and with a dozen of jumps off the Dutch road curbs.
This mount helper was stress-tested with a Hero 9 Black in the following gravelbike ride, where I took some gravel paths at 25 km/h (the GoPro was on the mount throughout the entire trip of 73 km): https://www.komoot.com/nl-nl/tour/3313770144?share_token=a0uhjJVJ4jcwuZy8vePJK0sOXuuIHBrJI0K0gRHCjbCWZftqrU&ref=profile&t_s=referral&t_cid=route_share&t_ref_username=1877328544802
Photos also include four snapshots of videos made using this mount helper.
Technical highlights:
Material I used: PETG
Print orientation: On its side
Walls: 6
Infill: 30% - 40% Gyroid
Note that shedding weight further is not a good idea if you intend to use it on rough terrain. (previous iterations with thinner bodies have failed).
