1 / 9
SSD and HDD mounts for HP EliteDesk 800 SFF — image 1
1 / 9

SSD and HDD mounts for HP EliteDesk 800 SFF

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

These are replacement screw grommets for mounting 2.5" SSD/HDD and 3.5" HDD in an HP EliteDesk 800 SFF chassis.

Rating
0 / 5
Likes
0
Downloads
17
Makes
1
Views
60
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Share Alike

I picked up some used HP EliteDesk 800 (G3, I think) small-form-factor PCs and wanted to add some drives.  Additional drive mount screws are expensive, and I don't care about vibration dampening for SSDs.  I tried a couple of models that I found on Printables, that apparently were designed for other EliteDesk models - they didn't quite work for me.  I took a few measurements of the original screws and put together these models.

2.5" SSD mounts: I used M3x10mm screws that were left over from a 3D printer build.  Any M3x(8~12ish)mm should be fine.

3.5" HDD mounts: I designed these to use some #6-32 HDD screws that I had in a computer screws assortment kit, and they should be pretty common.

The original clip mechanism in the EliteDesk works to secure these.  I printed in ABS to avoid the brittleness, creep, and heat sensitivity of PLA.

Tags