1 / 9
SSD and HDD mounts for HP EliteDesk 800 SFF — zdjęcie 1
1 / 9

SSD and HDD mounts for HP EliteDesk 800 SFF

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These are replacement screw grommets for mounting 2.5" SSD/HDD and 3.5" HDD in an HP EliteDesk 800 SFF chassis.

Ocena
0 / 5
Polubienia
0
Pobrania
13
Wydruki
1
Wyświetlenia
46
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike

I picked up some used HP EliteDesk 800 (G3, I think) small-form-factor PCs and wanted to add some drives.  Additional drive mount screws are expensive, and I don't care about vibration dampening for SSDs.  I tried a couple of models that I found on Printables, that apparently were designed for other EliteDesk models - they didn't quite work for me.  I took a few measurements of the original screws and put together these models.

2.5" SSD mounts: I used M3x10mm screws that were left over from a 3D printer build.  Any M3x(8~12ish)mm should be fine.

3.5" HDD mounts: I designed these to use some #6-32 HDD screws that I had in a computer screws assortment kit, and they should be pretty common.

The original clip mechanism in the EliteDesk works to secure these.  I printed in ABS to avoid the brittleness, creep, and heat sensitivity of PLA.

Tagi