1 / 8
Solder Fume Extractor / Table Air Purifier / Battery-powered — image 1
1 / 8

Solder Fume Extractor / Table Air Purifier / Battery-powered

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I created a extractor for solder fumes. I had the bigger filter from my other project and wanted to use it via battery.

Rating
0 / 5
Likes
1
Downloads
5
Makes
0
Views
57
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

I used following components:

  • 1x ARCTIC P12 Pro - 120 mm Fan

  • 1x PUREBURG 3-layer filter (HEPA 13) for Afloia Q10 Aur purifier 

  • 6x Heated inserts M4

  • 6x M4 16mm skrews

  • 1x USB-C 2s Charging Board

  • 1x 2s Balancer and protection board

  • 1x PWM FAN Controller

  • 1x StepUp module

  • 1x Switch

  • 2x 18650 Lipo batteries 

  • 1x Lipo Battery holder of your choice. I used this one https://www.printables.com/model/999328-18650-battery-holder-case

The electronic cabling is a bit messy, but hey it works :-) To replace the Filter you only have to unskrew 2 screws and slide the cover. I used a gluegun to glue the electronic parts inside the case. 

This is a schematic drawing about the cabling:
I skipped the fuse :-)



I decided to use the fan in front of the filter, because they work better in this direction.
The filter is big enough to last for quite a long time. To mount the fan I used the original skrews sent with it. The battery should last at least 1h and I can recharge them via USB-C. I havn't tested how long the lipos can run the fan. 

I you want you can also add the solder fume picture to it in the slicer of your choice.

Tags