1 / 3
Over-the-Door Hook for Towels & Coats – 38/40/42 mm Doors, No Supports — image 1
1 / 3

Over-the-Door Hook for Towels & Coats – 38/40/42 mm Doors, No Supports

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

No-drill door hook for towels and coats. Thin 2.4 mm strap, deep J-hook, 3 door sizes, ~34 min print, no supports.

Rating
0 / 5
Likes
10
Downloads
45
Makes
0
Views
105
Reviews
0

Updated at source:

Model information

Category
Bathroom
License
Standard Digital File License

A sturdy over-the-door hook for towels, bathrobes, coats and bags. No screws, no drilling – just hang it on the top edge of the door. It prints in one piece lying on its side, with no supports, in about half an hour.

  • Three sizes for standard interior doors: 38, 40 and 42 mm thick leaves (0.6 mm clearance, so it slides on without scratching).

  • Thin top strap (2.4 mm) fits the usual gap above the door, so the door still closes. Check that your door has at least ~3 mm of clearance at the top.

  • Deep J-hook: 22 mm opening, 16 mm raised tip with a rounded end, so towel loops and coat hangers don't slide off.

  • Strong by orientation: printed on its side, the whole profile lies in the layer plane, so the load bends it along the layers, not across them.

  • Size: 74–78 × 78 × 24 mm (depends on door size), hook reaches 31 mm from the door face.

Print settings

  • Orientation: as supplied (on its side, profile flat on the bed). No supports, no brim.

  • 0.20 mm layer, 3 walls, 15–20% infill. PLA or PETG (PETG for a bathroom door).

  • Time on Bambu Lab A1 with PLA at 0.20: ~34 min / 13.8 g per hook (all three sizes).

  • Tip: print 2–4 at once on one plate.

Designed from scratch by bezbajzlu.

Tags